Skip to Content
Battery Chainsaw support
Information about the guide bar and saw chain
Information about the guide bar and saw chain
WARNING: Use protective gloves when you use or do maintenance on the saw chain. A saw chain that does not move can also cause injuries.
Replace a worn or damaged guide bar or saw chain with the guide bar and saw chain combination recommended by Husqvarna. This is necessary to keep the safety functions of the product.
Refer to Accessories section of your manual, for a list of replacement bar and chain combinations that we recommend.
1
Guide bar length
Guide bar length, in/cm. Information about the guide bar length can usually be found on the rear end of the guide bar.
2
Number of teeth
Number of teeth on bar tip sprocket (T).
3
Chain pitch
Chain pitch, in inch. The distance between the drive links of the saw chain must align with the distance of the teeth on the bar tip sprocket and drive sprocket.
4
Number of drive links
Number of drive links. The number of drive links is decided by the type of guide bar.
5
Bar groove width
Bar groove width, in inch or mm. The groove width in guide bar must be the same as the chain drive links width.
6
Chain oil hole and hole for chain tensioner
Chain oil hole and hole for chain tensioner. The guide bar must align with product.
7
Drive link width
Drive link width, in mm or inch.
On this page