Battery Chainsaw support

⚠️ There is a high probability that the chain gets damaged after being thrown out of the guide bar. Please make absolutely sure that refit is possible or replace the chain with a new one that properly fits your guide bar.

• If the chain gets thrown as soon as you start the saw, it is very probable that you are not using the correct chain type/size or rim/drive sprocket.

• If the chain gets thrown during use, then it probably needs to be clean and adjusted for tension.

Read the steps and follow the links below for further instructions.

1
First of all please make absolutely sure the chain is the correct type/size for your guide bar and rim/drive sprocket.

The bar and chain fit up chart for US models can be found here.

2
Verify that the guide bar nose sprocket is not worn and replace it if necessary. See the Spare Parts link below.

3
Clean the chain and guide bar before assembling the chain again. Instructions in the link below.

4
Adjust the tension of the chainsaw. Instructions in the link below.

IMPORTANT: If you don't feel confident or want advice in any of these steps, contact Husqvarna service in the link below.