Petrol Chainsaw support

Believe it or not, but “how do I start a chainsaw?” is a common question (or at least a frequent Google search) amongst chainsaw users. In this guide we’ve put together some tips on how to get your saw ready to perform.

There are two correct ways to start your chainsaw: on the ground or with the saw between your legs. No matter which starting method you choose, remember that the chain brake should always be activated. Many chainsaw models can be started in what is known as half-throttle position. If the brake is not activated when starting one of these models, the chain may rotate.

Starting a cold engine

<iframe width="100%" src="

1
Activate the chain brake.

2
If the model is equipped with a decompression control – press this.

3
Activate the choke. If the saw is equipped with Air Purge/fuel pump, press the bulb a few times until the fuel is visible inside it and thereby enters the carburetor.

4
Starting on the ground: Put your right foot in the rear handle and keep a firm grip on the front handle with your left hand. Starting with the saw between your legs: Place the rear handle between your thighs and behind your right knee. Hold the front handle firmly with your left hand.

5
Pull the starter handle with your right hand. Repeat until the engine fires.

6
Push the choke (half-throttle) and pull until the saw starts.

7
Accelerate so that the engine idles and then release the chain brake.

Starting a hot engine

<iframe width="100%" src="

When the engine is hot, it’ll start without the choke. Follow the instructions above, but disregard the points relating to the choke. If the engine is difficult to start, apply half-throttle. You access the half-throttle function by first fully activating the choke, then moving the control back.