Skip to Content
Snow Thrower support
How to start the engine, electric start
1
Put the ON/OFF key into the ignition slot (B). Do not turn the key.
2
Turn the fuel ON/OFF switch (C) to the ON position.
This solution applies only for ST 424/427/430.
3
Put the throttle control (A) to the FAST position.
4
Put ON/OFF key to the ON position.
5
If the temperature is lower than -17° C (0° F), push the primer 3 times.
CAUTION: Do not push the primer too many times. It can prevent the engine from starting. If the engine is flooded, wait for a few minutes before you try to start. Do not push the primer.
This solution applies only for ST 424/427/430.
6
Turn the ON/OFF key to START. When the engine starts, release the key.
CAUTION: Do not run the starter for more that 5 seconds each time you try to start. Wait 5 to 10 seconds between each try.
7