Skip to Content
Zero Turn Mower support
Arms uneven
1
Turn ignition key "OFF" and remove the key. Make sure the blades and all moving parts have completely stopped.
2
Sitting on the seat, in the operators position, press both control levers forward. If both control levers line up with each other, then no adjustment is needed. If they do not line up, follow instructions below.
Try this solution
Adjust the control levers
1
Turn ignition key "OFF" and remove the key. Make sure the blades and all moving parts have completely stopped.
2
Sitting on the seat, in the operators position, press both control levers forward. If both control levers line up with each other, then no adjustment is needed. If they do not line up, follow instructions below.
3
Identify which control lever moves further forward. Slightly loosen the bottom hex bolt (about 1/2 turn) on the opposite control lever.
4
Move both control levers to the front again and apply more pressure to the control lever that you loosened to bring the two control levers in line with each other. Tighten hex bolts.
On this page