Skip to Content
Help Center US
Zero Turn Mower supportMoving Machine By Hand
Zero Turn Mower support

Zero Turn Mower support

Moving Machine By Hand

Moving Machine By Hand

WARNING! Make no adjustments without:

  • the engine stopped,

  • the park brake activated
    IMPORTANT INFORMATION: To manually push the mower, engage the hydro bypass levers on both sides, pull both steering / park brake controls inwards and push machine.

When pushing or pulling the mower, engage the EZT bypass linkages. The EZT bypass linkages are located on the rear of the frame, below the rear engine guard.

1
Raise the deck into the highest cutting position.

2
Move the steering / park brake controls inwards to the neutral position.

3
Pull the EZT bypass linkages up and out of the keyhole slots. Release the levers with the head outside the frame and held in the bypass position.

4
To reengage the EZT’s to drive, reverse the above procedure. Load the machine into truck or trailer by driving slowly up the ramps. DO NOT LIFT! The machine is not intended to be lifted by hand.

WARNING! Bypass linkages are located close to the muffler. To prevent burns, the engine should be shut off and allowed to cool before the bypass linkage levers are handled.

WARNING! Use more caution when loading the machine into a truck or trailer using ramps. There is the possibility of dangerous injury or death if the machine falls off the ramps.

Need more help?

Ask a different questionZero Turn Mower support
Select a different product
On this page
Copyright - 2024 Husqvarna AB. All rights reserved.Sitemap
Get the latest updates!HOMEOWNER NEWSLETTER SIGN-UPPRO NEWSLETTER SIGN-UP
Privacy PolicyTermsDo Not Sell My Personal Information (CA Residents)Report Suspected Violations